MacDon M200 Instrukcja Operatora Pobierz pdf (Strona 10)

SET-UP INSTRUCTIONS

Form 169216 January 2009

8

25. Align the deck pivot with holes in clevis by

raising or lowering the floor jack and insert

shaft (P). At bottom install one regular hex

nut (H) and torque the nut to 250 ft-lbs. Then

install lock nut (G) and tighten against nut

(H). It is important that these nuts are

properly torqued. Add grease to grease

zerk (R).

26. Attach turnbuckle (Q) from linkage to deck.

Use outer pivot (shown) if used with A30/40

or D60 header and use inner pivot if used

with an R80 header.

27. Adjust turnbuckle (Q) length so the deck is

approximately 100 mm or 4” from the right

hand drive tire. The turnbuckle length

should be about 530 mm long for the R80

header and 630 mm long for the A30/40 or

D60 header. Note: The lift cylinder is single

acting and it is pressurized with the draper

drive circuit. Therefore when the deck is

setup for the R80 the tractor needs to be

running for the deck to be in its most forward

position. This adjustment can be fine-tuned

when the hydraulics setup is complete.

28. Raise backsheet (R) on deck and install gas

shock (S) in center hole with nut (T).

A

30/40 & D60

R80

Q

100 mm or 4”

S

T

R

S

T

P

H

G

M

N

R

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 40 41

Komentarze do niniejszej Instrukcji

Brak uwag